KSD-G2

The Keepsake Security Device - Generation 2 (KSD-G2) was designed to provide an additional level of security for the CB-2000, CB-3000, and The Curve.  It is made in 3 standard sizes for the following soft shaft sizes: 1-1/2", 1-3/8", and 1-1/4".

The new design for the CB-2000 adds a ridge around the outside of the sleeve
that allows the KSD-G2 to snap into the tube.  Also added to both models are small grooves in the sleeve for greater holding power!

All men are made a bit different.  Because of the physical makeup of some men, they
have found that it is possible to pull out of the CB-2000, CB-3000, or The Curve,
regardless of the configuration of rings and spacers that they use.  In order to assist
the man in his desire to stay chaste for his Keyholder, and to give the Keyholder the
peace of mind that she deserves, Kept For Her designed and offers the KSD-G2.  

Any man in chastity comes to points of frustration where he will do anything to get
out of his CB.  The KSD-G2 will aid in preventing the man from pulling out of the
tube and masturbating.

KSDG2+CURVE		KSDG2+CB3000		KSDG2+CB2000

How the KSD-G2 Works
The KSD-G2 fits onto the locking pin and goes partway into the tube, while a
part of it is on the outside of the tube.  The KSD-G2 works by adding
constriction and friction to the male shaft, thus making attempts at pulling out
difficult, if not impossible.  The inside diameter of the KSD-G2 is considerably
smaller than the shaft size it was ordered for (see chart on Measuring page).  If
indeed you are able to pull out, you will not get back in without your Keyholder
finding out.  You will be in big trouble!!  

The KSD-G2 will not cause fluid backup (unless you specify the wrong size and that can be easily corrected!).  Also, the KSD-G2 will not cause pain during arousals.  It is very comfortable to wear and to stay hygienically clean while locked up for long periods of time.

The KSD-G2 is made out of UHMW plastic, which has the qualities of being lightweight,
resistant to any oils or lotions, and easy to modify if necessary.  Each KSD-G2 is professionally machined on a $270,000.00 Okuma CNC machine by a company that we have contracted with.  This process assures you of consistent quality and exacting
tolerances from one unit to the next.

What is the difference between the KSD-G2 for the CB-2000 and the one for the
CB-3000/Curve?  The KSD-G2 fits 1/2" into the chastity tube of the
2000/3000/Curve.  The opening of the CB-3000 and The Curve is the same so the
same KSD-G2 fits both.  The opening of the CB-2000 is larger.  So a different
KSD-G2 had to be designed to fit snugly into the CB-2000.  The fit is rather snug for
all of the units so that you can snap the KSD-G2 into the tube and put the tube and
KSD-G2 on together.  

The KSD-G2 can be made to fit any man, so there is no reason for your Keyholder
not to keep you locked up... safe and secure for her pleasure alone!!

The KSD-G2 is made for three shaft sizes, however special sizes are easily made!
For help in knowing what size to order, go to measuring.